GeoMax Zipp02 - Page 20

Zipp02 | 20Preparation before Measurement
Method of setting
Setting of items
1. Press and hold HOLD button + 0SET button and
press ON/OFF button.
2. Release ON/OFF button when full character
display appears and release HOLD + 0SET
buttons when four beeps are heard.
The instrument enters into initial setting mode and
the LCD displays:
3. Press button or button for turning over
pages and selecting options.
4. Press button for selecting specific content in
the options.
5. Finally, press V% button to confirm and enter into
angle measuring mode.
1. Unit of angle
• UNIT A: 360° (Degree)
• UNIT B: 400 (GON)
• UNIT C: 6400 (Mil)
2. Zero position of vertical angle
• ZEN==0: Zenith being 0°
• ZEN==90: Zenith being 90°