Gerber DCS 2500 - Cutter Head and (6) Beam

Page 20
English
Note: The cutter and computer are energized separately.
Turn on Cutter
Note: The computer must be running before turning the
cutter on.
1) Push the control box AC Power switch to the ON position.
2) Push the Primary Reset button when prompted on the computer.
3) Push the Status Board Reset button when prompted on the
computer.
4) Log on to the computer with username and password when
prompted.
Turn off Cutter
Note: The computer must be turned off separately.
5) Push the control box AC Power switch to the OFF position.
6) Turn computer power off.
(5) Cutter Head and (6) Beam
The head and beam move along the table surface and are controlled by
CutWorks. The cutter head moves along the width of the cutting table on
the beam. The cutter head holds tool holders, a pen tool, and the laser
light.