Gerber DCS 2500 - Page 43

Page 35
English
5) Home the cutter.
Warning: Beam moves.
On the Machine menu, click Home Cutter.
6) Open GT-TEMPLATE.nc file.
a) On the File menu, click Open.
b) Navigate to C:/ProgramFiles/CutWorks/Samples GT-
TEMPLATE.nc.
c) Click Open.
The NC Import Options box, General tab opens (see Figure 18).
7) Enter the following properties as shown.
· In the Text Height box, type 1.250.
· Select the Group into parts in Sequence (N) Numbers check
box.
· In the Units list, select 1/100 in.
· Select All Data Absolute.