46
The following table describes the configurable items.
Item Description
Physical buttons
(+) Plus Button
To assign a function or app to a hardware button on
your device. Tap a button name and select from the
available options in the popup menu.
(-) Minus Button
Fn Button
LTE
All support
firmware
To select the LTE module firmware that matches your
mobile network operator. If your operator is not listed
in the menu, select GENERIC.
Global Navigation Satellite System
GNSS receiver To enable or disable the below systems.
GLONASS
SBAS
To clear all GPS data in memory and restart the GPS
positioning, tap Cold start. The on/off switch will
turn back to the off position when you exit this
setting screen.
Touchscreen
Mode To select the touchscreen mode. Options are:
Water: This mode works best with fingertip.
this when liquids (such as raindrops) are falling on
the screen and should be rejected as input. Use
your finger in this mode.
Stylus: This is the default setting. Select this if you
are using the stylus. This mode responds to finger
touches as well.
Barcode
Turn off
barcode scanner
To select the countdown time for the barcode scanner
to turn off after a trigger action. With each trigger
action, the scan beam will turn off upon a successful
scan or timeout.