GL-INET Opal User Manual

Page 64 | 153
3.0 firmware supports SMB2, and if you need SMB3, use WinSCP to router,
edit /etc/samba/smb.conf.template.
Change the "max protocol = SMB2" to
"min protocol = SMB1"
"max protocol = SMB3", then save and exit WinSCP.

GL-INET Opal Specifications

General

RAM	128 MB DDR2
WiFi	802.11b/g/n
USB Port	1 x USB 2.0
VPN Support	OpenVPN, WireGuard
Operating System	OpenWrt
Processor	QCA9531, 650MHz
Flash Storage	16 MB
Ethernet Ports	2 x 10/100 Mbps
Power Input	5V/2A