General Information
01-22 79032996 A Rev.
SERVICE PROCEDURES
Keep lubricants in clean, closed containers. Clean
funnels, measures, and other handling equipment before
and after use. Clean fittings, plug openings, and other
lubrication points before servicing. Inspect and clean
plugs and other fittings before installing.
SERVICE PERIODS
Frequency specifications, shown in the Lubrication and
Maintenance charts, are according to normal operating
conditions. If the combine is being operated in extreme
weather or dust conditions, lubricate more frequently.
Change engine oil filter every oil change.
NOTE: Monitor the engine hour meter to make sure that
all maintenance intervals are met.
m
WARNING: Lower header or feeder to
ground or raise and engage header lift
cylinder stop. Stop combine engine and
remove start key before doing any
lubrication or maintenance function.
To Next Page
Loading...