28PowerUp Installation and Operation Manual
ERROR CODES
Error
Code
Name / Description Suggested Action
081 OVP (Over Voltage Protection)
The PowerUp charger will auto-recover once the voltage
is normal. If it doesn’t, restart the PowerUp charger or
contact customer support.
083 UVP (Under Voltage Protection)
082 OCP (Over Current Protection)
Unplug the charging coupler and plug it in again.
If the same error code occurs, seek support from the
supplier of the EV.
085 RCD
Unplug the charging coupler and restart the PowerUp
charger.
If the same error code occurs, contact customer support.
086 RCD self-test fail
Restart the PowerUp charger.
If the same error code occurs, contact customer support.
087 Welding Fault
Restart the PowerUp charger.
If the same error code occurs, contact customer support.
088 GMI (Ground Monitor Interrupter)
The PowerUp charger will auto-recover.
Check the ground system and wait 10 seconds for
recovery.
Ensure an electrician is on hand in case you need to
open the PowerUp charger system.
091, 100 Pilot Error
Unplug the charging coupler, the PowerUp charger will
auto recover.
If the same error code occurs, contact customer support.
084, 090,
092, 098
OTP (Over Temperature
Protection)
Wait for the PowerUp charger to recover and check if
any heat source is around the PowerUp charger. If yes,
try to remove the heat source.
093, 094,
099
NTC Error
Restart the PowerUp charger.
If the same error code occurs, contact customer support.
096
Meter
communication failed
Restart the PowerUp charger.
If the same error code occurs, contact customer support.
097 Driving Fault
Unplug the charging coupler and restart the PowerUp
charger.
If the same error code occurs, contact customer support.
106 DIP switch setting failed Refer to "Configuring the DIP Switches" on page 19.
110 Internal communication failed
Restart the PowerUp charger.
If the same error code occurs, contact customer support.
To Next Page
Loading...
