7PowerUp Installation and Operation Manual
Federal Communications Commission (FCC) Interference State-
ment
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the party responsible
for compliance could void your authority to operate the equipment.
RF EXPOSURE STATEMENT
The equipment must not be co-located or operating in conjunction with any
other antenna or transmitter. The equipment complies with FCC RF exposure
limits set forth for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance 20cms between the radiator
and your body or nearby persons.
To Next Page
Loading...
