5PowerUp Installation and Operation Manual
• Secure the working area against access by unauthorized persons.
• The PowerUp charger must be connected to a grounded, metal, permanent
wiring system or an equipment grounding conductor must be run with the
circuit conductors and connected to the equipment grounding terminal or
lead on the PowerUp charger.
• Use a measuring instrument to check that there is no voltage.
• Use appropriate protection when connecting to the main power distribution
cable.
• Do not use the device to charge or supply other devices.
• Do not touch the contact pins of the charging plug when operating.
• Do not use non-GM approved adapters, conversion adapters or cord exten-
sion sets with the PowerUp charger.
• Do not use this PowerUp charger if the flexible power cord or charging cable
is frayed, the insulation is broken, or the device shows signs of damage.
Warning
When using electric products, basic precautions should always be followed,
including the following. This manual contains important instructions that shall
be followed during installation, operation and maintenance of the unit.
• Read all the instructions before using this product.
• This device should be supervised when used around children.
• Do not put fingers into the electric vehicle connector.
• Damaged cables may only be replaced by electricians.
• Do not use this PowerUp charger if the enclosure or the vehicle connector is
broken, cracked, open, or shows any signs of damage.
• Only pull the charging cable out of the charging socket by the charging
coupler.
Grounding Instructions
This product must be connected to a grounded, metal, permanent wiring
system, or an equipment grounding conductor must be run with the circuit
conductors and connected to the equipment grounding terminal or lead on the
product.
To Next Page
Loading...
