GM PowerUp - Intended Use; Important Safety Instructions; Safety and Compliance; Danger (Risk of Fire or Electric Shock)

4PowerUp Installation and Operation Manual
Intended Use
The device is developed, manufactured, tested and documented according to
the safety standards. If you comply with the instructions and safety instruc-
tions described for its intended use, the product normally will not pose any
danger in terms of property damage or to the health of people. The instruc-
tions contained in this manual shall be followed. Otherwise, sources of danger
may be produced or safety equipment may be rendered inoperable.
This device may only be used to charge Battery Electric Vehicles or Plug-in
Hybrid Electric Vehicles: In addition, the following conditions apply for intended
use:
• The device is exclusively for stationary installation.
• The device is designed for installation on a wall or pedestal.
• The device can be used for indoors and outdoors.
The following uses are considered as not intended:
• The device is not for charging electric vehicles that require ventilation for
charging.
• The device is not for use with plugs and/or sockets.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
SAFETY AND COMPLIANCE
Before installing, commissioning, and operating of the PowerUp charger,
review this manual carefully and consult with licensed contractors, licensed
electricians and installation experts to ensure compliance with local building
practices, climate conditions, safety standards, and state and local codes. GM is
not responsible for damage caused by failure to follow the safety instructions
and work instructions in this manual.
Danger (Risk of Fire or Electric Shock)
Dangerous voltages and currents can occur during operation of the PowerUp
charger. Before carrying out any work on the PowerUp charger, take the follow-
ing protective measures:
• Disconnect all electrical power prior to installing the PowerUp charger.
Failure to do so may result in electric shock, physical injury or damage to the
electrical system and charging unit.
• Do not remove circuit protective devices or any other component until all
electrical power is disconnected.