6PowerUp Installation and Operation Manual
Caution
• People can trip over cables lying around.
• To reduce the risk of fire, connect only to a circuit provided with 48 amperes
maximum branch circuit overcurrent protection in accordance with the 60
ampers.
• Always hang the charging cable in the holder supplied with the PowerUp
charger after use.
• All terminal screws must be tightened to the specified torque using a device
suitable for the defined torque range.
• Any repair work as well as the replacement of components on the PowerUp
charger may only be carried out by a qualified technician. Otherwise, the
warranty will become void.
• Damaged or illegible safety labels must be replaced.
• The PowerUp charger can only be installed by licensed contractors, or li-
censed electricians in accordance with all applicable state, local and national
electrical codes and standards.
• Seal all external connectors adequately to ensure an ingress protection
rating of IP6K6K.
• Warning notices, warning symbols and other markings attached to the
PowerUp charger must not be removed.
Moving and Storage
• When carrying and moving this product, do not lift or carry by the charging
cord.
Operator’s Duty of Supervision
• As the operator of the PowerUp charger, you are responsible for the safety
of the users and its proper use.
• As the operator of the PowerUp charger, you are responsible for the safety
of particularly vulnerable persons, especially children. Ensure that such
persons maintain a sufficient safety distance from the PowerUp charger and
the charging cable.
• Consider the emergency routes at the installation site.
• Do not install the device in areas with explosive gases or vapors.
To Next Page
Loading...
