Need help?Do you have a question about the GMS RX Series and is the answer not in the manual?
General safety and operational notes for correct system use, including power cutoff and personnel authorization.
Details on the product identification plate, its importance, and what to do if it's damaged.
Information on ATEX identification plates, including fields for ATEX-certified products.
Procedure for assembling and disassembling output hollow shafts, including cleaning and lubrication.
Steps for assembling and disassembling the block unit, emphasizing cleaning, lubrication, and screw tightening.
Guidance on aligning and assembling splined ends, flanges, or couplings, including clearance and welding considerations.
Instructions for reversing the free rotation direction of a gearbox with an anti-run back device.
Suitability and installation procedures for elastic couplings in various environments and conditions.
Mandatory safety precautions for ATEX environments, including electrical grounding and environmental checks.
Checks for ATEX products, including ventilation, heat sources, and temperature limits.
Classification of available oils (mineral, synthetic PAO, polyglycol) and selection criteria based on operating conditions.
Guidance on selecting oil viscosity for RX-STANDARD gearboxes based on speed, power, and lubrication system.
General maintenance checks, including temperature/noise monitoring, seal life, and screw tightening.
Recommended tightening torques (Nm) for screws according to UNI 5739 mat.8.8.
Specific ATEX provisions for dusty environments, requiring regular cleaning to prevent dust buildup.
To Next Page
General