ENG
4.0
GLT
Ω
L
IFT
O
PERATION AND
M
AINTENANCE
M
ANUAL
Page | 48
the furthest one is lifted.
7
Close the landing door.
• Visible:RED light
8
The maintenance technician can now work on the car roof without moving
the car, e.g. to clean or carry out maintenance operations, etc.
• Visible:RED light
EXIT SEQUENCE (ROOF)
STEP
ACTION NOTES
1
Lower the EN81-21 safety rails folding them on the car roof and make sure
the latches are inserted into the safety contacts.
If there is more than one safety rail: lower the furthest one and continue
until the one nearest the door is lowered.
• Visible:RED light
2
Open the landing door at the floor where you have decided to exit,
unlocking the lock manually.
• Visible:RED light
3
Climb down from the roof and stand on the landing.
• Visible:RED light
4
Release the emergency stop (red button).
• Visible:RED light
5
Close the landing door.
• Visible:RED light
6
Turn the key on the “RESET” switch outside the bottom landing to the pit
to reset the electrical panel functions (audible buzzer sound).
• Visible: no light
7
The lift is back in service (floor call buttons are not lit).
• Visible: no light
IMPORTANT!
When exiting the pit and/or the car roof, the maintenance technician is advised to ensure that no
equipment or tools have been left behind that can impair smooth operation of the lift or even
cause accidents.