GMV GLT 81-21 - Page 73

10991793EN
-
19.10.2022
4.0
ENG
GLT Ω L IFT
O PERATION M ANUAL
Page | 73
IX.b Lower car stop mechanical device
 Verify that the lower car stop mechanical device (LCSMD) has a regular and easy movement
and that all the fixing bolts are are properly tightened.
 Verify that the electrical safety contact (SBCA and SBCRn) is clean, in good condition and
working properly
 Verify that the pre-activated car stops device (AMI) and its connecting levers have a regular and
easy movements and that their locking bolts are properly tightened.
 Verify that the electrical safety contacts (SPR and SPR1) are clean, in good condition and
working properly

Verify that the intervention device (AMI) is working properly.
Or
 Verify that the lower car stop mechanical device (LCSMD) has a regular and easy movement
and that all the fixing bolts are are properly tightened.
 Verify that the electrical safety contact (SBCA and SBCRn) is clean, in good condition and
working properly
 Verify that the cables in the sheaths run properly and, if necessary, lubricate them.

Verify that the handles and cable ends are securely fastened
IX.c Remote unlocking car door device
 Verify that the unlocking device is working properly.
 Verify that the cable in the sheath run properly and, if necessary, lubricate it.

Verify that the fixing clamps are clean and properly tightened.
IX.d Remote unlocking landing door device
 Verify that the unlocking device is working properly.
 Verify that the cable in the sheath run properly and, if necessary, lubricate it.

Verify that the fixing clamps are clean and properly tightened.
IX.e Remote command panel
 Verify that all the devices on the remote command panel work properly.
IX.f Remote hand pump

Verify the hand pump is working properly and there is no fluid leak from the fittings and piping.
IX.g Bracket for lifting hook
 Verify that the bracket for the lifting hook is securely fixed to the guides.
X. TFR - S YSTEMS WITH HEADROOM AND / OR PIT REDUCED
X.a Car stop mechanical device
 Verify that the pre-activated car stop device for headroom and /or pit reduced (CSMD - AMI) and
its connecting levers have a regular and easy movements and that their locking bolts are
properly tightened.
 Verify that the actuation brackets (ST and / or SF) and those of the additional final limit switches
(SFCT and / or SFCF) are in the correct position and that that their locking bolts are properly
tightened.
 Verify that the electrical safety contacts on the sling (SPR and SPR1) are clean, in good
condition and working properly
 Verify that additional final limit switches (SFCT and / or SFCF) are clean, in good condition and
working properly
 Verify that the intervention device (AMI) is working properly.
 Verify that green (LVT and / or LVF) and red (LRT and / or LRF) lights in the headroom and / or
pit are clean, visible from the floor, and work properly.