04 OTHER User Manual V1.5-2021-01-21
27
Other Questions
Q: Is there a quick way to make the system work?
A: The shortest way, please refer to S-BP QUICK INSTALLATION INSTRUCITONS.
Q: What kind of load can I connect on Back-Up side?
A: Please refer to user manual on page 11.
Q: Will the warranty of the inverter still be valid if for some special conditions we cannot 100%
follow the installation or operation instructions of the user manual?
A: Normally we still provide technical support to problems caused from disobeying the
instructions of the user manual, but we cannot guarantee a replacement or returns. So if there
is any special condition when you cannot 100% follow the instrucions, please contact after-sales
for suggestions.
4.3 Disclaimer
The S-BP series inverters are transported, used and operated under environmental and electrical
conditions. Manufacturer has the right not to provide after-sales services or assistance under
following conditions:
• Inverter is damaged during transfer.
• Inverter's warranty has expired and extended warranty is not bought.
• Inverter is installed, retted or operated in improper ways without authorisation from
manufacturer.
• Inverter is installed or used under improper environment or technical condition mentioned in
this user manual, without authorisation from manufacturer.
• Installation or conguration of the inverter does not follow requirements mentioned in this
user manual.
• The inverter is installed or operated against the requirements or warnings that are mentioned
in this user manual.
• Inverter is broken or damaged by any force majeure like lightening, earthquake, re hazard,
storm and volcanic eruption etc.
• Inverter is disassembled, changed or updated on software or hardware without authorisation
from manufacturer.
• Inverter is installed, used or operated against any related items in international or local policies
or regulations.
• Any non-compatible batteries, loads or other devices connected to BT system.
• The Battery-Ready inverter activation code is obtained through illegal channels.
Note: Manufacturer will keep right to explain all the contents in this user manual. To insure IP65, inverter
must be sealed well, please install the inverters within one day after unpacking, otherwise please seal all
unused terminals/holes, terminals/holes are not allowed to be kept open, conrm that there is no risk of
water or dust entering the terminals/holes.
To Next Page
Loading...
Need help?
General