Goodwe SBP Series - Mounting

7
02 Installation Instructions User Manual V1.5-2021-01-21
2.3.2 Mounting
Deliver the inverter carefully.
300mm
500mm
200mm 200mm
Upward
Downward
Front
Both sides
---------- 300mm
------ 500mm
------------- 300mm
-------- 200mm
300mm
Wi-Fi
Reset/Reload
SYSTEM
GRID
BACK-UP
ENERGY
COM
Wi-Fi
BATTERY
FAULT
2019
• Pack the inverter securely for transport.
• Carefully transport the inverter using the carrying handles in the boxes.
• Do not subject the inverter to shocks during the transport.
• Make sure that the arrows on the box always point upwards during the transport.
• Secure the inverter rmly in place for transport.
Note:
• Move the inverter with care to prevent device damage and personal injury.
• Do not use the wiring terminals and ports at the bottom to support any weight of the inverter.
• Place a foam pad or cardboard under the inverter to protect the inverter enclosure from damage.
Inverter cannot be installed near ammable, explosive or strong electro-magnetic
equipment.[1]
Lift the inverter from the packing case and move it to the specied installation position.
The inverter is suitable for mounting on concrete or other non-combustible surface only.
Mounting Support Requirements
• The mounting support shall be nonammable and reproof.
• Make sure that the support surface is solid enough to bear the product weight load.
• Do not install the product on the support with poor sound insulation to avoid the noise
generated by the working product, which may annoy the residents nearby.
• Do not install the productnear equipment with strong electromagnetism.