How to fix tails and streaks in Graco PerformAA 15 Paint Sprayer pattern?
Tails and streaks in the spray pattern from your Graco Paint Sprayer can occur due to several reasons. The tip may not be fully atomized or could be worn or plugged. Try cleaning the tip first. If that doesn't work, check the tip for wear and flow rate. Also, increasing the fluid pressure or decreasing the tip orifice size may help.
What causes an irregular pattern from Graco PerformAA 15 Paint Sprayer?
An irregular spray pattern from your Graco Paint Sprayer could be due to a partially plugged spray tip or dirty/plugged air cap holes. Try cleaning or replacing the tip and the air cap.
Why does my Graco Paint Sprayer leave an orange peel texture?
Orange peel texture when using your Graco Paint Sprayer can occur if the paint coverage is too thick or if there's too much atomization air. Decrease the fluid pressure and reduce the air pressure.
How to fix entrained air/sugary finish with Graco Paint Sprayer?
Entrained air, a sugary finish, or a champagne finish with your Graco Paint Sprayer can be caused by too much atomization air or over agitation of the paint supply. Decrease the air pressure and reduce the agitation of the paint supply.
Why is my Graco PerformAA 15 Paint Sprayer producing an uneven spray pattern?
An uneven spray pattern with your Graco Paint Sprayer may be due to dirty or plugged air cap holes, a worn tip, or incorrect operator technique. Try cleaning the air cap and the tip. Also check the tip for wear and flow rate. If the issue persists, review your spray technique.
What to do if Graco PerformAA 15 Paint Sprayer causes paint runs or thick coverage?
Paint runs or excessive paint coverage thickness with your Graco Paint Sprayer can be caused by too much fluid flow, a worn tip, incorrect tip size, or poor operator technique. You should check the tip for wear and flow rate, decrease the tip orifice size, and review your spray technique.
Why is my Graco PerformAA 15 Paint Sprayer fogging or overspraying?
Fogging, overspray, or dry spray from your Graco Paint Sprayer can happen if there's too much atomization air or too high fluid pressure, or if the tip size is incorrect. Reduce the air pressure and decrease the fluid pressure. You might also need to increase the tip orifice size.
How to prevent rough finish or specking with Graco PerformAA 15?
A rough finish or specking when using your Graco Paint Sprayer can be caused by too much atomization air, too much fan pattern adjustment, or too much distance between the gun and the part. Try decreasing the air pressure and the tip pattern size. Also, adjust the distance between the gun and the part.
General| Brand | Graco |
|---|---|
| Model | PerformAA 15 |
| Category | Paint Sprayer |
| Language | English |
To Next Page