Repair
34 3A8099A
Fan Tube Replacement
Replace the fan tube with kit 26B715.
1. Follow the Pressure Relief Procedure, page 15.
2. Use a hex wrench to loosen the fan tube plug (18).
3. Pull the fan tube plug (18) out of the gun. Remove
the fan tube (20) from the gun.
4. Insert a replacement fan tube (20) into the gun
body.
5. Lubricate the o-ring (19) on the replacement fan
tube plug (18).
6. Thread the fan tube plug (18) into the gun body.
Tighten with a hex wrench.
Fluid Cartridge Replacement
Replace the fluid cartridge (6) entirely with a compatible
replacement kit. See Fluid Cartridge Repair Kits,
page 55.
Remove Fluid Cartridge Procedure
1. Follow the Pressure Relief Procedure, page 15.
2. Remove the fluid and air hoses from the gun.
3. Loosen the retaining ring (8b) by hand to remove
the air cap assembly (8).
NOTE: Clean the air cap assembly (8) daily. See Daily
Gun Care, page 19.
4. Trigger the gun while loosening the fluid cartridge
(6) with the gun tool (29) until the cartridge spins
freely.
5. Follow the Remove the Trigger, page 30,
instructions to release the fluid cartridge (6) from the
gun.
F
IG. 48 Fan tube assembly
18
20
19
Lubricate lightly.
3
FIG. 49: Remove the fluid cartridge
NOTICE
Always trigger the gun to remove or tighten the fluid
cartridge to prevent seat damage.
To Next Page
Loading...
