Graco PR70 - Operator (Manual) Mode Operation

Operation
312759W 57
3. Press the Start/Stop Shot button ( ) to start a
shot.
4. If Auto-Sequencing is not enabled for the Active
Sequence the next shot in the sequence will be
selected. Press the Start/Stop Shot button ( ) to
start the shot.
5. Repeat step 4 until the sequence has been com-
pleted.
Operator (Manual) Mode Operation
Dispense
1. Select Operator (Manual) mode. See Change
Operating Mode, page 55.
2. Press and hold the Start/Stop Shot button ( ) to
begin dispensing.
3. Release the Start/Stop Shot button ( ) to stop
dispensing.
The Start/Stop Shot button ( ) changes to the
Abort/Cancel button ( ) during the shot. Press
the Abort/Cancel button on the screen ( ) or the
Abort/Cancel button on the keypad ( ) to can-
cel the shot if necessary.
When the shot is complete or if the shot is aborted,
the Abort/Cancel button on the screen ( )
changes back to the Start/Stop Shot button ( ).
Operator (Manual) Mode does not use the pre-
defined shots or sequences.