Setup
20 312062A
11.Ground system
a. Reactor: is grounded through power cord. See
page 17.
b. Spray gun: connect whip hose ground wire to
FTS, page 18. Do not disconnect wire or spray
without whip hose.
c. Fluid supply containers: follow your local code.
d. Object being sprayed: follow your local code.
e. Solvent pails used when flushing: follow your
local code. Use only metal pails, which are con-
ductive, placed on a grounded surface. Do not
place pail on a nonconductive surface, such as
paper or cardboard, which interrupts grounding
continuity
f. To maintain grounding continuity when flushing
or relieving pressure, hold a metal part of spray
gun firmly to the side of a grounded metal pail,
then trigger gun.
12.Check hydraulic fluid level
Hydraulic reservoir is filled at the factory. Check fluid
level before operating the first time, and weekly
thereafter. See Maintenance, page 32.
13.Lubrication system setup
Component A (ISO) Pump: Fill ISO lube reservoir
(LR) with Graco Throat Seal Liquid (TSL), Part
206995 (supplied).
a. Lift the lubricant reservoir (LR) out of the
bracket (RB) and remove the container from the
cap.
b. Fill with fresh lubricant. Thread the reservoir
onto the cap assembly and place it in the
bracket (RB).
c. Push the larger diameter supply tube (ST)
approximately 1/3 of the way into the reservoir.
d. Push the smaller diameter return tube (RT) into
the reservoir until it reaches the bottom.
e. The lubrication system is ready for operation.
No priming is required.
Important: The return tube (RT) must reach the
bottom of the reservoir, to ensure that isocyanate
crystals will settle to the bottom and not be
siphoned into the supply tube (ST) and returned to
the pump.
LR
RT
ST
RB
ti9911a
To Next Page
Loading...
Need help?
General
