765041938 Rev. 002 28
Changing a running program
Fig. 33 Fig. 34
Touching the program symbol (fig. 33) opens the settings menu (fig. 34), where you can
change the specifications for program phases that have not been run yet.
Touching the field with the ending time for the program (fig. 35) opens the settings menus for
date and time (fig. 36) for purposes of changing the ending time for the program, see the
above for the descriptive section "Changing the ending time for the program" (page 22) /
"Changing the date of the ending time for the program" (page 23).
Fig. 35 Fig. 36
Here, the date can be changed by touching the
date fields. Selection of the time can be opened
by touching the time window, fig. 20. Here, the
time can be entered and saved with "OK". Exit
the menu without making changes with "<".
The ending time for the program may only be
changed before the start of the thawing phase!
Fig. 20
To Next Page
Loading...
