System sub menu includes the following options:
• Network
o Internet Protocol
Selects Prefer IPv4 / Prefer IPv6 / IPv4 only or IPv6 only. The default
setting is “IPv4 only”.
o IP Setting
Selects IP mode (DHCP/Static IP/PPPoE); Configures PPPoE account
ID and password; Configures static IP address, Netmask, Gateway,
DNS Server 1 and DNS Server 2.
o 802.1X
Enables/Disables 802.1X mode; Configures 802.1x identity and MD5
password.
o Layer 2 QoS
Configures 802.1Q/VLAN Tag and priority value. Select “Reset VLAN
Config” to reset VLAN configuration.
• Wi-Fi Settings (GRP2612W & GRP2614 & GRP2615 & GRP2616 only)
o Enable/disable
Enables/disables Wi-Fi.
o Scan
Scan available Wi-Fi networks.
• Bluetooth Settings (GRP2614/GRP2615 & GRP2616 only)
o Bluetooth Status
Displays the status of Bluetooth
o Bluetooth MAC
Displays the GRP phone’s Bluetooth MAC address.
(Bluetooth MAC address is GRP phone’s MAC address plus 1)
o Power
Turns on/off the Bluetooth feature.
o Handsfree Mode
Enables/Disables Handsfree mode
o Bluetooth Name
Specifies GRP phone name when discovered by other Bluetooth
devices.
o Start Scan
Starts to scan other Bluetooth devices around the phone. If found, user
could press “Pair” Softkey, and enter Pin code to pair to other devices.
To Next Page
Loading...
Need help?
General
