Grandstream Networks GXV3615 - Network Settings; IP Address and DNS Settings; PPPoE Configuration

Grandstream Networks, Inc. GXV3615 User Manual Page 20 of 37
Firmware Version 1.0.4.38 Last Updated: 03/2013
Networking Setting Page
This page allows user to configure network related parameters:
Figure 5: Networking Setting Page
• IP Address Configuration: Camera IP address configuration
o Dynamically Associated via DHCP: Default setting, DHCP server assign IP to camera.
o Statically Configured as: Static IP address configuration
• DNS Configuration: DNS server IP, must be configured correctly if using static IP.
• HTTP: Web access TCP port, default 80.
• PPPoE PPPoE account credential setting information.
NOTE:
 If camera behind SOHO router with port forwarding configuration for remote access, static IP or
static DHCP has to be used to avoid IP address change after router reboot.

TCP port above 5000 suggested if port forwarding HTTP remote access, due to some ISP would
block port 80 inbound traffic. For example, change the default HTTP port from 80 to 8088, to
make sure the port forwarding not likely be blocked.

In addition to HTTP port, RTSP port also required to be configured for port forwarding, in order
for remote party viewing the H.264 video.

If change the default port from TCP 80 to port “A”, then RTSP port should be “2000+A”. Both
TCP port “A” and “2000+A” should be configured for port forwarding in the router. For
example, the HTTP port changed to 8088, the RTSP port should be 10088, both 8088 and 10088
should be configured for port forwarding in order for remote camera video access.