Grandstream Networks HT801 Administration Guide

P a g e | 45
HT801/HT802 Administration Guide
Version 1.0.13.7
Use Privacy Header
Determines if the “Privacy header” will be presented in the SIP INVITE
message and if it includes the caller info in this header. If set to Default, it
will add Privacy header unless special feature is Telkom SA or CBCOM.
Default is Default.
Use P-Preferred-Identity
Header
Specifies if the P-Preferred-Identity Header will be presented in the SIP
INVITE message. If set to “default", the P-Preferred-Identity Header will be
omitted in SIP INVITE message when Telkom SA or CBCO is active. If set
to "Yes", the P-Preferred-Identity Header will always be presented. If set to
"No", it will be omitted.
Default setting is: Default.
Use P-Access-Network-Info
Header
With this feature enabled, device will populate the WAN access node with
IEE-802.11a, IEE-802.11b in P-Access-Network-Info SIP header.
Use P-Emergency-Info
Header
This feature support of IEEE-48-addr and IEEE-EUI-64 in SIP header for
emergency calls.
SIP REGISTER Contact
Header Uses
Specifies which address (LAN or WAN address) the device will detect to use
it in SIP Register Contact Header. When set to LAN, Contact header will
include local IP from ATA in REGISTER messages, while if set to WAN,
host/port/contact will be updated from SIP 401/403/404/407 Via header
"received"/"rport" parameters in REGISTER messages. Default is LAN
Address.
Caller ID Fetch Order
Selects the Caller ID display order which need to be respected by the
HT801/HT802. The available options are:
● Auto: When set to “Auto”, the HT801/HT802 will look for the caller ID
in the order of P-Asserted Identity Header, Remote-Party-ID Header
and From Header in the incoming SIP INVITE.
● Disabled: When set to "Disabled", all incoming calls are displayed
with "Unavailable".
● From Header: When set to “From Header”, the HT801/HT802 will use
the FROM header to display the caller ID.
Allow SIP Factory Reset
Allows to reset the devices directly through SIP Notify. If “Allow SIP Factory
Reset” is set to “YES” under FXS PORT, then the ATA receives the NOTIFY
from the SIP server with Event: reset, the HT should perform a factory reset
after the authentication.
The authentication in this case can be either with:

Grandstream Networks HT801 Specifications

General

Brand	Grandstream Networks
Model	HT801
Category	Telephone Accessories
Language	English