WP820 Administration Guide
Version 1.0.1.15
Defines port number for PTT multicast address.
Emergency
PTT/paging volume
Set default volume for PTT/paging when emergency channel/group is used.
Enable or disable group paging.
Defines default paging group. When pressing and holding the PTT button, paging
will be initiated using the default group.
Defines priority paging group. Paging received on priority group will take
precedence over active paging on normal group.
Defines emergency group for paging. Emergency group has the highest priority.
Paging using emergency group will take precedence over paging on priority or
normal group. Please note paging to emergency group will not be rejected even
when device has enabled DND.
Defines whether to accept paging while device is in active call. If set to "No",
device will ignore paging while in active call. If set to "Yes", while in active paging
call, device will accept paging if it has the same priority; If device is in active SIP
call, device will accept paging and put the SIP call on hold.
Set Caller ID displayed on the call interface during paging
Set payload size for paging.
Selects the codec type for the paging call. The list includes: G.722, G.711, Opus.
Defines paging group. Users can configure whether to use the group for transport,
accept, join group and its label. Only available and joined group will be displayed
in paging group list. If users need send or receive paging, "Transport" and
"Accept" must be enabled for this group.
Defines default channel for PTT. When pressing and holding the PTT button, PTT
will be initiated using the default channel.
Defines priority channel for PTT. PTT received on priority channel will take
precedence over active PTT on normal channel.