EasyManuals Logo

Grandstream Networks WP820 Administration Guide

Grandstream Networks WP820
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
P a g e | 51
WP820 Administration Guide
Version 1.0.1.15
Filter Characters
Sets the characters for filter when dial out numbers. Multiple characters could be
set. For example, if set to "[()-]", when dial (0571)-8800-8888, the character "()-"
will be filtered and dial 057188008888 directly. The default setting is [()-]
Escape '#' as %23 in
SIP URI
Determines which characters will be included in the SIP INVITE URI if end users
input #. If it is set to Yes”, the phone will replace the # by %23. Otherwise, it will
include # in the SIP INVITE message. The default setting is “Yes”.
Phone Settings/Ring Tone
Auto Config CPT by
Region
Configures whether to choose Call Progress Tone automatically by region. If set
to "Yes", the phone will configure CPT (Call Progress Tone) according to different
regions automatically. If set to "No", you can manual configure CPT parameters.
The default setting is "No".
Call Progress Tones:
Dial Tone
Second Dial Tone
Ring Back Tone
Busy Tone
Reorder Tone
Confirmation Tone
Call-Waiting Tone
Configures ring or tone frequencies based on parameters from local telecom. The
default value is North American standard. Frequencies should be configured with
known values to avoid uncomfortable high pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing (“On timein ‘ms’) while OFF is the period of silence.
In order to set a continuous ring, OFF should be zero. Otherwise it will ring ON ms
and a pause of OFF ms and then repeat the pattern. Up to three cadences are
supported.
Please refer to the document below to determine your local call progress tones:
http://www.itu.int/ITU-T/inr/forms/files/tones-0203.pdf
Call-Waiting Tone
Gain
Adjusts the call waiting tone volume. Users can select "Low", "Medium" or "High".
The default setting is "Low".
Default Ring
Cadence
Defines the ring cadence for the phone.
The default setting is: c=2000/4000.
Phone Settings/PTT/Multicast Settings
PTT
Settings
PTT multicast
address
Defines PTT multicast address.

Table of Contents

Other manuals for Grandstream Networks WP820

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Grandstream Networks WP820 and is the answer not in the manual?

Grandstream Networks WP820 Specifications

General IconGeneral
BrandGrandstream Networks
ModelWP820
CategoryCordless Telephone
LanguageEnglish

Related product manuals