WP820 Administration Guide
Version 1.0.1.15
Upload Device
Configuration
Uploads configuration file “cfgMAC.xml” or “cfgwp820.xml” to the phone.
Note: Reboot is required to take effect.
Specifies when the firmware upgrade process will be initiated; there are 4 options:
• No: The phone will only do upgrade once at boot up.
• Check every day: User needs to specify “Hour of the day (0-23)”.
• Check every week: User needs to specify “Hour of the day (0-23)” and “Day
of the week (0-6)”.
• Check at a period Time: User needs to specify “Hour of the day (0-23)”
Note: Day of week is starting from Sunday. The default setting is “No”.
Firmware Upgrade
and Provisioning
Defines the phone’s rules for automatic upgrade. It can be selected from:
• Always Check at bootup.
• Always Check at bootup, when Firmware/Config pre/suffix changes.
• Skip the Firmware Check.
The default setting is “Always Check at bootup”.
If set to "Yes", the phone will automatically start upgrading after downloading the
firmware file. Otherwise, users would need to confirm in the prompted message
on the LCD screen to start upgrading process. The default setting is "Yes".
Allow DHCP Option
43 and Option 66 to
Override Server
Obtains configuration and upgrade server’s information from DHCP server using
options 66 and 43.
Note: If DHCP Option 66 is enabled, the phone will attempt downloading the
firmware file from the server URL provided by DHCP, even though Config Server
Path is left blank. Default setting is “Yes”.
DHCP Option 120
Override SIP Server
Configures the phone to allow the DHCP offer message to override the Config
Server Path via the Option 120 header. The default setting is "Yes".
Allow DHCP Option
242 (Avaya IP
Phones)
Enables DHCP Option 242. Once enabled, the phone will use the configuration
info issued by the local DHCP in Option 242 to configure proxy, transport protocol
and server path. The default setting is “Yes”.
Disable SIP NOTIFY
Authentication
Disables the SIP NOTIFY Authentication on the phone. If set to “Yes”, the phone
will not challenge NOTIFY with 401. The default setting is “No”.
To Next Page
Loading...
