Figure 27: Audio Control – Noise Shield 2.0
Ringtones
Setting the Ringer Volume
To configure the desired ringer volume, proceed as follows:
1. Press Menu to bring up operation menu and go to Settings.
2. Navigate to Basic Settings, and then select Sound tab.
3. User can configure the silent and vibrate modes and also the voice ringtones by pressing the left and right arrow keys to change repeatedly and set the
desired volume.
4. Press “Back” (right softkey) to confirm the new configuration settings.
Notes:
8 levels are supported. Level 8 is the highest level. Level 5 is the default.
appears when silent mode is enabled. In this mode no ring will be played for incoming calls.
Figure 28: Ringer Volume
Setting the Ringtones
You can change the ringer melody for an incoming call. The device has different ringer melodies and in order to configure the desired melody, proceed as
follows:
1. Press Menu to bring up operation menu.
2. Use arrow keys to reach Settings 🡪 Basic Settings, and then select Sound tab.
3. Go to “Default Ringtone”, and choose the desired ringtones, press “Save” to confirm the ringtones selected and the new ringtones will be set
successfully.
To Next Page
Loading...
