Grandstream Networks WP825 - Date and Time; Call Operations; Placing Calls

Figure 29: Calls Default Ringtone
Date and Time
On the WP810/WP822/WP825 the Date and time are displayed on the idle screen and it obtains the date and time from the Simple Network Time Protocol
(SNTP) server by default. If your phone cannot obtain the date and time from the SNTP server, you need to configure the date and time manually. You can
configure the time format and date format respectively. The handset supports two formats for time (12 Hour or 24 Hour) and three date formats
(DD/MM/YYYY; MM/DD/YYYY; YYYY/MM/DD).
To configure date and time manually
1. Press Menu to bring up operation menu.
2. Use arrow keys to reach Settings 🡪 Basic Settings, and then select Date and Time tab.
3. Press “Back” softkey to apply your changes.
Figure 30: Date and Time Settings
Reboot
To reboot the handset, please refer to following steps:
1. Access the handset menu 🡪 Settings 🡪 Advanced Settings 🡪 Reboot.
2. A confirmation LCD message will be displayed to confirm the reboot, press “Reboot” button to reboot the phone or “Cancel” to cancel the reboot.
Figure 31: Reboot
CALL OPERATIONS
Placing calls
To place calls, you can use the following mode: