3. A dialog box will pop up to confirm factory reset.
4. Click OK to restore the phone to factory settings.
Figure 66: Web GUI – Confirm Factory Reset
CHANGE LOG
This section documents significant changes from previous firmware versions. Only major new features or major document updates are listed here. Minor
updates for corrections or editing are not documented here.
Firmware Version 1.0.11.51
Added support for new LCD modules through hardware versions on WP822 and WP825 models. [Configuring the LCD]
Added support for Hebrew language. [Hebrew]
Firmware Version 1.0.11.43
No Major Changes.
Firmware Version 1.0.11.40
No Major changes.
Firmware Version 1.0.11.34
Added support for attended transfer feature on WP810 as WP822/WP825. [Attended Transfer]
Added support for new Audio control configuration parameters. [Audio control]
Added support for 802.11k and 802.11v Wi-Fi Standards. [Wi-Fi settings]
Firmware Version 1.0.11.28
Added support to allow PTT audio to come through the 3.5 mm audio jack output. [PTT]
Added support to disable/enable the function to hang up the call when the device is placed upside down. [Ending a call]
Added support for attended Transfer before the answer. [Attended Transfer]
Firmware Version 1.0.11.22
No major changes.
Firmware Version 1.0.11.20
Added support to connect up to 20 SSIDs [Auto Connection]
Added door system support and GDS settings [Grandstream Door System Integration]
Added support for Off-hook Auto Dial [Off-hook Auto Dial]
To Next Page
Loading...
