GRAPHTEC CC330-20 Craft ROBO - Page 43

CHAPTER 3. CRAFT ROBO CONTROLLER 3-19
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE CH 2. CONNECTION AND PREPARATION
INDEXAPPENDIX A CH 4. CUTTING DATA SAVED ON SD CARD CH 3. CRAFT ROBO CONTROLLER
Thedesignorientationhasnotbeenspeciedcorrectly.Pleasecheckthe"Design
Orientation"settinginyourapplicationprogram.
 Make the setting once again. If the problem is still not resolved, consult the manufacturer of the
application software that you are using.
Thedistancesbetweentheregistrationmarkshavenotbeenspeciedcorrectly.
Pleasecheckthe"DistancebetweenRegistrationMarks"settinginyourapplication
program. (Displayed only for the CC330-20.)
 Make the setting once again. If the problem is still not resolved, consult the manufacturer of the
application software that you are using.
ThespeciedMediaTypecannotbeused.PleasespecifyadifferentMediaType.
 The default Media Type has been specied, or characters ( / : * ? < >) that cannot be used for
the Media Type name have been specied. Please enter the Media Type name once again.