GRAPHTEC CE6000-40 Plus - Page 104

CE6000-UM-251-9370 7-7
7 ELECTRICAL ADJUSTMENTS
How to select the sufx model
(1) Load a sheet of paper into the plotter.
(2) Turn on the power while pressing the FAST and ENTER keys.
(3) Select the Language and the Length Unit if the Language selection menu is displayed (See section
7.5.).
(4) Press the PAUSE/MENU key at the following menu.
(5) The following menu is displayed, and then press the right arrow key (ADJ).
(6) The following menu is displayed.
(7) Press the up arrow key until the following menu is displayed.
(8) Press the F4 key (SELECT SUFFIX) to display the following menu.
(9) Select the sufx model by using the UP or DOWN arrow key.
(10) Press the ENTER key after the sufx model is selected.