GRAPHTEC CE6000-40 Plus - 7.10 Adjusting the Offset of the Registration Mark Sensor

CE6000-UM-251-9370 7-19
7 ELECTRICAL ADJUSTMENTS
7.10 Adjusting the Offset of the Registration Mark Sensor
This adjustment will set the registration mark sensor position and the tool position.
If you have replaced the registration mark sensor, you must adjust the offset of the registration mark
sensor.
If you replace the main board, use the following procedure to input the recorded adjustment values.
Preparation
This adjustment have to be performed after the sensitivity of sensor adjustment (See section 7.9.).
Print out the target sheet (see next page) on a printer.
The specication of the cross mark is 30 mm line length, and 0.3 to 0.5 mm line width.
The target sheet does not need to print if the recorded adjustment values are input.
How to set the registration mark sensor offset
(1) Set an target sheet of paper into the plotter.
Set the A4 size of paper if the recorded adjustment values are input.
(2) Mount a water-based ber-tip pen into the plotter.
Mount a water-based ber-tip pen to the backward position of tool holder if the plotter is STD model.
Tool holder
Bracket to hold tool
Tool holder
Bracket to hold tool
STD Model
STU Model
Mount the ber tip-pen to the
backward position of tool holder.
(3) Turn on the power while pressing the FAST and ENTER keys.
(4) Select the Language and the Length Unit if the Language selection menu is displayed (See section
7.5.).
(5) Press the F3 key (SHEET) when the following menu is displayed.