GRAPHTEC CE6000-40 Plus - 8.6 Self Diagnostic Test

CE6000-UM-251-9370 8-7
8 SERVICE MODES
8.6 Self Diagnostic Test
Operation status can be tested by self diagnostic test by operating the sensors and switches following the
instruction on the screen.
Operation
(1) Conrm that the power is turned off.
(2) Turn the power on without loading the media.
(3) Press the PAUSE/MENU key at the following menu.
(4) The following menu is displayed, and then press the left arrow key (TEST).
(5) The following menu is displayed, and then press the Up arrow key.
(6) The following menu is displayed, and then press the F1 key (DIAGNOSTICS).
(7) The following menu is displayed, and then press the F1 key (DONE).