CE6000-UM-251-9370 9-11
9 TROUBLESHOOTING
E05006 Distance between the bottom left
and top right of the AREA setting
is less than 10 mm.
Perform the AREA setting again.
E05007
Test pattern for the TOOL
OFFSET ADJ. cannot start
plotting because the start position
is at the edge of the media.
Set the start position inside the
media.
9.8 Caution Message
Error
Code
LCD Display Description
W06001
When the command set is auto, the DUMP mode us not available.
W06002
When panel cutting is on, copy and origin setting cannot be changed.
To Next Page
Loading...
