CE6000-UM-251-9370 6-14
6 DISASSEMBLY AND REASSEMBLY
6.2.7 Push Roller Sensor
How to detach the push roller sensor
(1) Detach the center cover (See section 6.1.3.).
(2) Detach the pen block (See section 6.2.6.).
(3) Disconnect the push roller sensor exible cable from the Y-relay board.
(4) Remove the push roller sensor exible cable that is attached with double-sided adhesive tape to
the Y-slider.
(5) Remove the M3L6 binding head screw holding the push roller sensor bracket, and then detach
the push roller sensor bracket from the Y slider.
Push roller sensor exible cable
Push roller sensor board bracket
Y slider
M3L6 binding head screw
(6) Disconnect the push roller sensor exible cable from the push roller sensor board.
(7) Remove the M3L5 binding head screw holding the push roller sensor board, and then detach the
push roller sensor board.
Push roller sensor board bracket
Push roller sensor board
M3L5 binding head screw
How to reinstall the push roller sensor
(1) Reattach the Push roller sensor board in the reverse order in which it was detached.
To Next Page
Loading...
