CE6000-UM-251-9370 6-13
6 DISASSEMBLY AND REASSEMBLY
How to reinstall the pen block
(1) Install the registration mark sensor board to the pen block in the reverse order in which it was
detached.(The CE6000-120AP does not have registration mark sensor board, therefore you don’t
need to install it to the pen block of CE6000-120AP.)
(2)
Mount the pen block to the Y slider.
(3) Move the pen block to center of the Y bar and lower the Push roller when measuring the pen
block height.
(4) Fasten the two M4L6 binding head screws to attach the pen block so that there is a gap of 10 mm
between the bottom of the pen block and the cutting mat. Perform a visual check to make
sure that the pen block is not mounted at an angle.
10 mm
Cutting mat
(5) Reattach the other parts in the reverse order in which they were detached.
(6) Perform the pen force adjustment (See section 7.7.).
(7) Perform the registration mark sensor offset adjustment (see Section 7.9).
To Next Page
Loading...
