CE6000-UM-251-9370 7-21
7 ELECTRICAL ADJUSTMENTS
(10) Press the F2 key (RM SENSOR POS ADJ). The following menu is displayed.
Press the F3 (X=) or F4 (Y=) to input the recorded adjustment values if you replace the main board.
Input the recorded adjustment value by using the Up arrow key or Down arrow key with the following
menu.
Press the Left arrow key after input the recorded adjustment values. The following menu is displayed.
Press the ENTER key to store the value.
Skip to step (18)
(11) Press the F2 key (MANUAL) if the registration mark sensor was replaced. The following menu is
displayed.
(12) Press the F2 key (SCAN). The following menu is displayed.
To Next Page
Loading...
