CE6000-UM-251-9370 2-20
2 PARTS NAMES and FUNCTIONS
(7) Using the middle sheet supporting pipe, attach the basket assembly from step 6 to the media stocker,
then attach the joints from the assembly from step 5 to the long sheet supporting pipe from step 6.
The middle of the basket should pass over the back end of the center bar.
Basket
Center bar
Sheet supporting pipe (long)
Sheet supporting pipe (middle)
Media stocker
Sheet supporting
pipe (long)
Basket
Joint
Joint
(8) Mount the plotter on the stand by inserting the positioning pins on the stand into the positioning holes
on the underside of the plotter. Fasten with four socket head cap screws (two on each side), using
the Allen wrench�
Positioning pin
Caster stoppers
Socket head
cap screw
Socket head
cap screw
(9) Tighten the socket head cap screws loosely fastened in Step 2.
To Next Page
Loading...
