GRAPHTEC CE6000-40 Plus - Page 38

CE6000-UM-251-9370 3-4
3 OPERATIONS
Contents of Operation from Menu Screen
You can use the [SIMPLE] key on the default screen to switch between Simple mode and Normal mode.
Switching will reset the machine.
In Simple mode you can change easy settings from the menu screen.
In Normal mode, you will be able to change more detailed settings.
Simple mode and Normal mode are independent from one another. The settings of the mode you’re
currently in will take precedence.
Simple mode
In Simple mode, [1], [2], [3] keys can be used.
Menu screen
(Simple mode)
Contents of the operation and settings that is displayed in MENU screen with [PAUSE/MENU] key is as
following:
[1] (MEDIA) .....................................Set the setting of the condition for the media.
[2] (I/F) ............................................ Set the settings of the condition for the interfacing with the control
computer.
[3] (ADV) ......................................... Set the settings of the conditions for the basic operation of the plotter,
such as display language, unit of the measurements.
[PAUSE/MENU] ..............................It will close the MENU screen and return to default screen.
Normal mode
In Normal mode, [1], [2], [3], [4] and [
], [ ], [ ] keys can be used.
Menu screen
(Normal mode)
Contents of the operation and settings that is displayed in MENU screen with [PAUSE/MENU] key is as
following:
[1] (TOOL) ....................................... Set the setting for the operation of the tool.
[2] (ARMS) ...................................... Set the settings and operation to position the tool and media, such as
automatic scanning of the registration marks by the ARMS.
[3] (AREA) ......................................Set the settings for area, magnication, rotation, reverse, etc., of the
cutting.
[4] (MEDIA) ..................................... Make the setting of the condition for the media.
[Up arrow] (I/F) ...............................Make the settings of the condition for the interfacing with the control
computer.
[Down arrow] (ADV) .......................Make the settings of the conditions for the basic operation of the
plotter, such as display language, unit of the measurements.