CE6000-UM-251-9370 6-22
6 DISASSEMBLY AND REASSEMBLY
How to reinstall the Y motor
(1) Install the Y motor pulley to the Y-motor.
Install the Y motor pulley at
the end of the Y motor shaft.
So the surface of end of motor
shaft and surface of pulley
should be at.
Y motor pulley
(2) Tighten the two M3L4WP set screws holding the Y motor pulley.
(3) Install the Y-motor to the Y-motor bracket.
(4) Hang the Y drive belt on the Y motor pulley and the Y idler pulley.
(5) Spread a suitable quantity of the Shinetu silicon grease G501 on the Y-motor pulley and Y-idler
pulley.
(6) Use the force gauge to pull the Y-drive motor pulley ange with a 1.8 kg to 2.0 kg force.
(7) Tighten the three M3L6 binding head screws that hold the Y-motor.
(8) Move the pen block and check the tension of the Y-drive belt.
(9) Reinstall the other parts in the reverse order in which they were detached.
To Next Page
Loading...
