CE6000-UM-251-9370 6-25
6 DISASSEMBLY AND REASSEMBLY
How to reinstall the X-motor
(1) Install the X motor pulley to the X-motor.
Install the X motor pulley at
the end of the X motor shaft.
So the surface of end of motor
shaft and surface of pulley
should be at.
X motor pulley
(2) Tighten the two M3L4WP set screws holding the X motor pulley.
(3) Install the X-motor to the right side plate.
Mount the X motor that the encoder connector of X
motor to be faced to the front.
X Motor
Encoder connector
(4) Hang the X drive belt on the X motor pulley and the X drive shaft pulley.
(5) Spread a suitable quantity of the Shinetu silicon grease G501 on the X-motor pulley and X drive
shaft pulley.
(6) Use the force gauge to push down the X-drive motor pulley ange with a 1.8 kg to 2.0 kg force.
(7) Tighten the three M3L6 binding head screws that hold the X-motor.
(8) Turn the X drive shaft and check the tension of the X-drive belt.
(9) Reinstall the other parts in the reverse order in which they were detached.
To Next Page
Loading...
