CE6000-UM-251-9370 1-2
1 INTRODUCTION
CE6000-120AP
Item CE6000-120AP
CPU 32-bits CPU
Configuration Grit rolling
Drive system Digital servo
Maximum cutting area 1190 mm x 50 m
Guaranteed precision cutting area
*1
1190 mm x 3 m
Mountable media width
*2
Minimum: 594 mm
Maximum: 1220 mm
Available roll media core diameter 3 inch
Available roll media outer diameter Maximum: 200 mm
Available roll media weight Less than 20 kg
Number of push roller 5
Maximum cutting speed 600 mm/s
(in all directions)
Specifiable cutting speeds (cm/s) 1–10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60 cm/s
Cutting Pressure 0.2 to 4.4 N
(20 gf to 450 gf) (38 steps)
Minimum character size 5 mm (0.197 in) for alphanumeric Helvetica med. Font
Mechanical resolution 0.005 mm
Programmable resolution GP-GL: 0.1/0.05/0.025/0.01 mm; HP-GLTM
*3
: 0.025 mm
Repeatability accuracy
*1
Max. 0.1 mm/in unit of 2 m (Designated file and cutting condition)
No. of pens mountable 2 pens
Compatible cutter type Supersteel cutter blades
Compatible pen type Water-based fiber-tip pens and oil-based ballpoint pen
Interfaces RS-232C/USB (Full Speed)
Buffer capacity 2 MB
Command modes GP-GL, HP-GL
*3
Display panel Liquid crystal graphic display (240dot x 128dot)
Rated power supply 100 to 120, 200 to 240 V AC, 50/60 Hz
Power consumption 100 VA
Operating environment 10°C to 35°C, 35% to 75% RH (Non-condensing)
Conditions for guaranteed precision 16°C to 32°C, 35% to 70% RH (Non-condensing)
External dimensions
(W x D x H)
Approx.
1575 x 1200 x 1250 mm (Including stand)
Weight 46 kg (Including stand)
*1: Varies depending on the type of Graphtec-authorized lm and the cutting conditions
*2: The accuracy of minimum media width is when the push rollers are set to 5 mm from both edges of media.
*3: HP-GL
TM
is a registered trademark of Hewlett-Packard Company.
To Next Page
Loading...
