CS400/300 4 – 3
4. LOADING A DOCUMENT
4.2 Loading a Document
Insert the document onto the document-scanning table face down so that it presses against
the rollers evenly.
How to use the document guides
CS400
• Move the document guides to the left and right until they are adjusted to the document
width.
• Place the document between the document guides.
• Move the document guides back to the edges of the scanner after you have loaded the
document.
• This ensures that the document does not get damaged if it is fed at an angle.
Document guides
Document-scanning table
CS300
The document guides are attached to the document-scanning table via magnets. Place
them at the edges of the document in alignment with the document width.
Remove the document guides after you have loaded the document in order to ensure that
the document does not get damaged if it is fed at an angle.
Document guides
Document-scanning table
To Next Page
Loading...
