5 – 2 CS400/300
5. DAILY MAINTENANCE
5.2 Cleaning the Document Hold-Down Unit
(1) Turn off the scanner.
(2) Open the top cover as described in Section 5.1 “Opening and Closing the Top Cover”.
Document hold-down unit
Latch
Latch
(3) Wipe clean the underside of the document hold-down unit (see below) using a soft
cloth that has been soaked in water or diluted neutral detergent and thoroughly wrung
out.
(4) Wipe the document hold-down unit once again using a soft, dry cloth (remove all
moisture).
(5) Close the top cover as described in Section 5.1 “Opening and Closing the Top Cover”.
Take care not to get your fingers caught in the cover.
Scanning may be affected if the underside of the document hold-down unit becomes
scratched or dirty. It must be cleaned when necessary.
To Next Page
Loading...
