CS400/300 B – 1
APPENDIX B. STANDARD SPECIFICATIONS
APPENDIX B. STANDARD SPECIFICATIONS
Item CS400 CS300
Document size ANSI E to ISO A4
Maximum width: 1090 mm; minimum width: 210 mm
Effective scanning area Width : 1016 mm (centered)
Length : 16 m*
1
Guaranteed scanning
841 mm
× 1189 mm
precision range*
3
Document thickness 1.5 mm or less (including the carrier sheet)
Optical resolution 600 dpi
Interpolated resolution 50 to 800 dpi, in 1-dpi increments
Main scanning system Contact image sensor system (Five A4 sensors in a zigzag pattern)
Sub scanning system Document travel (sheet through) system
Scanning speed*
2
Monochrome: Approx. 0.55 ms/line
9 ips at 400 dpi
Color: Approx. 1.65 ms/line
3 ips at 400 dpi
Scanning precision*
3
±0.1%, ±5 pixels
Gradation Monochrome: Bilevel, intermediate tones (dithering, error diffusion)
Gray : 256 shades
Color: 8-bit, 24-bit 8-bit
Threshold value Digital signal processor enables automatic setting of the threshold
value (monochrome scans only)
Color space sRGB compatible
Light source LED (RGB)
Interface*
4
USB 2.0, IEEE 1394
Output Image data
Rated power supply 100 to 120/200 to 230 VAC ±10%, 50/60 Hz
Operating environment Temperature: 10°C to 35°C
Humidity: 35% to 80% RH (non-condensing)
Power consumption 135 VA or less (60 W or less)
External dimensions
1205
× 957 × 715 mm (W× H× D) (including stand)
(approx.)
Weight Approx. 40 kg (including stand)
*
1
Documents up to approximately 16 m in length (driver software limitation) can be scanned. However, the actual
document length that can be scanned is limited by the available memory (hard disk or other data storage device)
of the computer to which the scanner is connected, and also by the grade of the medium being scanned.
*
2
Excluding data-transfer time
*
3
Notes on scanning precision
Scanning precision may vary slightly depending on the grade and thickness of the medium being scanned,
and on the operating conditions. The precision figures above were measured under the operating conditions
described below.
• Test chart used : Mylar sheet #200
• Guaranteed precision conditions : Temperature 20 ±3°C; humidity: 60% ±10% RH
• Document hold-down unit setting : Standard
*
4
The USB 2.0 and IEEE 1394 interfaces cannot be used at the same time.
To Next Page
Loading...
