GRAPHTEC CS400 - Page 71

CS400/300 Index – 1
INDEX
A
Assembling the scanner ............................ 2-1
C
Calibration ................................................... 5-7
Carrier sheet, using the .............................4-6
Caster .......................................................... 2-4
Control panel .............................................. 2-6
Cover sensor .............................................. 2-4
D
Daily maintenance ...................................... 5-1
Deviation due to scanner
specifications ...........................................6-4
Document grade and thickness ................ 4-1
Document hold-down unit .......................... 5-2
Document hold-down unit, cleaning the .... 5-2
Document guides ........................................ 1-2
Document length ........................................ 4-1
Document loading operation ..................... 4-2
Document-scanning table .......................... 4-2
Document support wire .............................. 2-7
Document types.......................................... 4-1
Document width .......................................... 4-1
E
ERROR LED ....................................... 2-6, 6-2
F
FORWARD key........................................... 2-6
I
IEEE 1394 connector ................................. 2-5
Image sensors, cleaning the ..................... 5-3
Interface ...................................................... 1-1
M
Missing data ............................................... 6-4
INDEX
O
Overlapped data ......................................... 6-4
P
Paper jam ...................................................5-6
PAPER LED ................................................2-6
Paper sensor .............................................. 2-4
Paper sensor, cleaning the ....................... 5-5
Part Names and Functions ....................... 2-4
Power cable, connecting the ..................... 3-2
POWER LED .............................................. 2-6
Power switch .............................................. 2-5
R
REVERSE key ............................................ 2-6
S
Scanner, assembling the ........................... 2-1
Scanning Master 21+, installing the .......3-13
Stand ...........................................................2-4
STOP key ................................................... 2-6
System requirements ................................. 3-1
T
Top cover .................................................... 5-1
Transparent contact plates ........................ 5-3
Troubleshooting .......................................... 6-1
U
USB connector ........................................... 2-5
Usage precautions ......................................viii
W
Warmup ........................................................ viii