1-3
Rear View
(15) Document support plates
(16) Cable clamp
(14) Main power switch
(10) USB connector (13) Power inlet
(12) Reset button (for network)
(11) Network connector
(10) USB connector ................. Used to connect the USB interface cable.
(11) Network connector
*
......... Used to connect the Network interface cable.
(12) Reset button (for network)
*
................................. This will initialize the network environment. Use the Network Utility to
reconfigure your settings. (see Section 2.7)
(13) Power inlet ........................ Used to connect the power cable.
(14) Main power switch ............ Used to turn the main power supply on or off.
(15) Document suppor t plates
................................. Used to support the document that is being ejected.
(16) Cable clamp ...................... Used to bundle the power cable and USB cable together and fasten
them in place.
*
CSX550-09 only
Caution
Both USB and network connection cannot be executed simultaneously. Please refrain
from connecting the USB cable and the network cable to a single computer at the same
time.
To Next Page
Loading...
