2-2
2.2 Turning the Power On and Off
The LED (blue) on the [POWER] button changes as follows to indicate the scanner's power supply
status.
• Unlit: The scanner is turned off.
• Lit: The scanner is turned on.
• Flashing: Flashes when the scanner is in power-saving mode.
Turning the Power On
(1) Connect the power cable.
(2) Turn on the main power switch (the I side).
ON
(3) Press the [POWER] button on the scanner's control panel.
When the scanner is in the power-on status, the [POWER] button LED lights blue.
ON
Turning the Power Off
Press the [POWER] button on the scanner's control panel.
When the scanner is in the power-off status, the [POWER] button LED is extinguished.
OFF
Checkpoint
• After the scanner has been turned off, wait at least five seconds before turning it on
again.
• If you do not plan to use the scanner for any length of time, turn off the main power
switch (the O side).
Caution
Do not turn off the main power switch (the O side) on the rear of the scanner while the
scanner is the power-on status.
To Next Page
Loading...
