2-6
Network Connection (CSX550-09 only)
Caution
Both USB and network connection cannot be executed simultaneously. Please refrain
from connecting the USB cable and the network cable to a single computer at the same
time.
Checkpoint
• You will need a network (LAN) cables and network hub to connect via Network. You will
need to purchase them separately.
• Structures of the network equipment and necessity of the router function depends on
the environment. For description, refer to the manual of the equipment, check with the
manufacturer or the network administrator.
• The scanner is compliant with 10BASE-T/100BASE-TX/1000BASE-T. Check your network
environment.
A Network cable is used to connect the scanner to the computer, via the respective Network interface
connectors.
Computer
Network connector
Reset button
(for network)
Network
Network cable
Network Connector
Network connector
POWER lampLINK lamp
Reset button
(for network)
After turning the scanner’s power on, confirm that the POWER lamp (right side) is flashing yellow.
LINK lamp (left side) flashes orange when connected to the 10Base-T/100Base-TX, and green when
connected to the 1000BASE-T.
Reset Button (for network)
This is used when the network environment has changed.
Turning the power on while pressing the reset button will cause the network environment to be
initialized.
Use the Network Utility to reconfigure your settings. (see Section 2.7)
To Next Page
Loading...
